Precautions for the construction of Viscoelastic Pipe Tape

Precautions for the construction of viscoelastic anticorrosive tape

Viscoelastic anticorrosive tape developed byJining Xunda Pipe Coating Materials CO.,Ltd, the leading brand of anticorrosive tape in China. It is a new product of anticorrosion. Pay attention to the following matters when using it:

The quality of the tape and the outer protective tape installation of the viscoelastomer anticorrosive tape should be made to achieve a smooth surface, even lap joints, there can be no bubbles, wrinkles and breakage, so a good construction will also help the performance of the product.

First of all, the surface of the pipe body should be treated. Under the condition that the temperature and air humidity meet the construction requirements, the surface of the pipe body is cleared of floating rust by mechanical descaling equipment, and the descaling grade reaches ST2.After descaling, the surface of the pipe body is dried by a hot blower.

It is wrapped with viscoelastic anticorrosive tape, in the completed surface treatment of the pipe section wrapped with a layer of viscoelastic anticorrosive tape, the end of its lap length with the original coating is not less than 50mm. from the end to one side of the order of winding, anticorrosive tape joints the minimum lap length of 10mm.

Wrapped with viscoelastic anticorrosive tape, do not have to maintain a large tension, and the edge of the tape and the lap part of the tape can be pressed with the hand.

For the anticorrosion work of valve flange and other joints, you can use anticorrosive paste to fill the connecting bolts flat, and then use the viscoelastic anticorrosive tape for wrapping treatment.